Digiplex DGP2-641BL Provozní pokyny stáhnout pdf (Strana 20)

20 System Manager’s Manual

9.3 SYSTEM MAINTENANCE

Under normal use your system requires no maintenance other than regular testing. We recommend that your

Installer change the battery every three years.

9.4 SYSTEM TEST

10.0 FIRE AND BURGLAR ALARMS

10.1 STANDARD FIRE ZONE

The Fire Zone may reset itself once the problem has cleared. If it does not, simultaneously

press and hold the [

CLEAR] and [ENTER] buttons for two seconds.

10.2 DELAYED FIRE ZONE

If you are unable to cancel the false alarm, your system will send an alert. Call your Central

Monitoring Station to advise them of the false alarm.

The Fire Zone may reset itself once the smoke has cleared. If it does not, simultaneously

press and hold the [

CLEAR] and [ENTER] buttons for two seconds or speak to your installer.

Speak to your Installer before

conducting a System Test

since the system must be

programmed to respond to

the test instructions. It is

normally recommended that

you conduct the system test

once a week, but contact your

Installer for instructions

concerning your particular

system.

How do I conduct the system test?

1) Call your Central Monitoring Station to advise them that you are testing your

system.

2) Enter your [ACCESS CODE].

3) Press the [8] button.

The system will test all its connections and can send a report to your Central

Monitoring Station. If the system detects a problem, the Trouble Display will

show on the LCD screen (Refer to section 7.0 on page 17). Call your Installer

for repairs if any Troubles occur.

During a fire alarm, the bell/

siren emits an intermittent

sound (

BEEP-BEEP-BEEP) until

silenced or reset. If the zone

is a Standard Fire Zone, your

system can immediately send

an alert to your Central

Monitoring Station.

How do I disarm a false alarm?

1) Enter your [

ACCESS CODE] on the keypad.

2) Call your Central Monitoring Station quickly to advise them of the false

alarm.

If the zone is a Delayed Fire

Zone, there is an automatic

delay before your system

contacts your Central

Monitoring Station. Refer to

Figure 10.1 on page 21 to

prevent unnecessary

reporting of false alarms.

What do I do if the fire alarm is accidentally triggered?

1) Press the [

CLEAR] button within 30 seconds of the alarm.

2) Clear the problem from the area (i.e. clear the smoke from around the smoke

detector).

3) If the problem remains after 90 seconds, the alarm will sound again. Press

[

CLEAR] again.

The system will delay reporting the alert for another 30 seconds.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Komentáře k této Příručce

Žádné komentáře

Digiplex DGP2-641BL Provozní pokyny Strana 20

Komentáře k této Příručce