Digiplex EVO641R Instalační manuál stáhnout pdf (Strana 8)

8 - Modules Programming Guide

Table 3: Special Characters

Using the Memory Key

Download Contents of the Memory Key to the LCD Keypad

1) Insert the Memory Key onto the keypad’s connector labelled “KEY”.

2) To download the contents of the Memory Key, enter the keypad’s programming mode and enter section number.

3) Once the keypad emits a confirmation beep, wait for a second confirmation beep and then remove the Memory

Key.

Copy Contents of the LCD Keypad to the Memory Key

1) Insert Memory Key onto the keypad’s connector labelled “

KEY”. Ensure that the ‘write protect’ jumper is on

(refer to Memory Key below).

2) To copy the contents to the Memory Key, enter the keypad’s programming mode and enter section number.

3) Once the keypad emits a confirmation beep, wait for a second confirmation beep and then remove the Memory

Key. Remove the Memory Key’s jumper if you do not wish to accidentally overwrite its contents.

Memory Key

Combus Voltmeter

To verify if the combus is supplying sufficient power, press and hold the [0] key, enter the [INSTALLER CODE] and press the [ACC] button. A

reading of 10.5V or lower indicates that the voltage is too low. The voltage may drop during the control panel battery test.

[510]

Download all from the Memory Key (LCD keypad sections [001] to [396] and all labels and messages) to the LCD

keypad.

[520] Copy the LCD keypad sections [001] to [396] and all labels and messages to the Memory Key.

Jumper ON:

Can copy and

download contents.

Jumper OFF:

Cannot override the

contents of the memory

key.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 59 60

Žádné komentáře

Digiplex EVO641R Instalační manuál Strana 8